Before you start

These steps are required for Wheel Front® Seller Protection. If a wheel is damaged in transit and it wasn't packed this way, your protection may be denied.

Take photos as you go. Photos of each stage, from the empty reinforced box to the sealed and labeled package, are your evidence if there's ever a dispute. Never reuse weak or damaged cardboard.

The six steps

1. Confirm dimensions

• Measure the wheel diameter and width accurately.
• Use the standard dimensional weight (DIM) sizes to choose the correct box.
• Never reuse boxes that are weak, damp or structurally damaged.

2. Reinforce the base

• Seal the bottom flaps from the inside first, for rigidity.
• Apply heavy-duty shipping tape along all main seams.
• Add rigid corner protectors to the inner walls.

3. Install foam cradles

• Place high-density foam inserts in all four corners.
• Make sure the foam gives a snug, tight fit.
• The goal is to stop the wheel moving inside the box at all.

4. Lower the wheel in

• Lower the wheel slowly into the cradle, face up.
• Don't drop it or let it hit the bottom of the box.
• The wheel lip and barrel must not touch the box walls.

5. Fill the gaps and protect the face

• Fill all remaining space with packing material.
• Add a thick protective plastic layer over the wheel face.
• Secure the wheel so it can't shift, even if the box is turned upside down.

6. H-tape and label

• Use the H-taping method: tape the center seam and both edge seams.
• Make sure every seam is fully sealed against moisture.
• Place the shipping label flat on top of the box, away from the edges.

Once the box is sealed and labeled, upload your packing photos and tracking number in your dashboard.